View shop
Add to basket
Item details
Shipping & delivery
This item will be posted to you by Irby Electronics within 3 days of receiving payment.
| Shipping destination | Cost | Additional items |
|---|---|---|
| United Kingdom | £2.10 | £0.80 |
| Europe | Doesn't deliver here | |
| United States | Doesn't deliver here | |
| Rest of the World | Doesn't deliver here | |
You have 14 days, from receipt, to notify the seller if you wish to cancel your order or exchange an item.
Unless faulty, the following types of items are non-refundable: items that are personalised, bespoke or made-to-order to your specific requirements; items which deteriorate quickly (e.g. food), personal items sold with a hygiene seal (cosmetics, underwear) in instances where the seal is broken; digital items.
Please note that if your order is being posted outside mainland UK, you (or the recipient) may have to pay customs or VAT charges and a handling fee. The seller is not responsible for any charges or fees that may incur.
Full description
This circuit contains one light-emitting diode which flashes on and off at a rate determined by the 555 timer integrated circuit and its associated components. The rate of flashing can be changed by adjusting the variable resistor with a small screwdriver (not supplied).
Different versions of the "Adjustable Flashing L.E.D." kit are available. Please choose the colour of the l.e.d. you would like in your kit. Choose either blue or green or red or white.
Please have a look at a working version of the "Adjustable Flashing L.E.D." circuit on the Irby Electronics YouTube channel.
When this circuit was tested, the Duracell Plus Power 9 volt battery was still producing a good light output after 40 hours of continuous use.
The circuit is made on track board (approx. 6 cm x 2 cm) and requires 1 x PP3 battery (not supplied). Precision soldering is ESSENTIAL for this kit so that solder on one track is not splashed across to an adjacent copper track.
These tools are needed to make this kit (not supplied):
small pliers for bending component leads and link wire,
small wire cutters for cutting component leads and link wire,
3 mm drill bit or sharp craft knife for breaking the copper track,
small, low power soldering iron, e.g. 15 watt, 18 watt or 25 watt.
Please read the safety warning in the About Irby Electronics section before ordering a kit.
Designed by John Doyle in Irby, Wirral
Other shop items you might like:
More items from this category