Check our curated gift guides
Kit 9: Darkness Detector

Kit 9: Darkness Detector

£6.30
4 Available
×

Add to basket

Item details

This item will be posted to you by Irby Electronics within 3 days of receiving payment.

Shipping destination Cost Additional items
United Kingdom £2.10 £0.80

You have 14 days, from receipt, to notify the seller if you wish to cancel your order or exchange an item.

Unless faulty, the following types of items are non-refundable: items that are personalised, bespoke or made-to-order to your specific requirements; items which deteriorate quickly (e.g. food), personal items sold with a hygiene seal (cosmetics, underwear) in instances where the seal is broken; digital items.

Please note that if your order is being posted outside mainland UK, you (or the recipient) may have to pay customs or VAT charges and a handling fee. The seller is not responsible for any charges or fees that may incur.

Read the Folksy Returns Policy.

Full description

Who hasn’t been afraid of the dark at some point?

The white light-emitting diode in this circuit automatically switches on at dusk and switches off as the light level increases at dawn. The switching on and off is controlled by the light-dependent resistor and transistor.

Please have a look at a working version of the "Darkness Detector" circuit on the Irby Electronics YouTube channel.

When this circuit was tested, the light-dependent resistor was covered with black tape to simulate darkness. The Duracell Plus Power 9 volt battery was still producing a good light output after 120 hours of continuous use.

The circuit is made on track board (approx. 6 cm x 2 cm) and requires 1 x PP3 battery (not supplied). Soldering is ESSENTIAL for this kit.

These tools are needed to make this kit (not supplied):

small pliers for bending component leads,

small wire cutters for cutting component leads and link wire,

3 mm drill bit or sharp craft knife for breaking the copper track,

small, low power soldering iron, e.g. 15 watt, 18 watt or 25 watt.

Please read the safety warning in the About Irby Electronics section before ordering a kit.

Designed by John Doyle in Irby, Wirral

Other shop items you might like:

More items from this category

  • Loved by 1 person